1. Log into Microsoft Account
2. Go to Subscriptions Page
3. Choose 365 Subscription
4. Choose Cancel option

The player does have a large effect on both those things. A player that supports the codec will not need server hw accept and hdr conversion as it will direct stream. A big issues is these codecs can cost money. So if the player doesn’t come with it the player needs to pay for it, something plex may be doing for those that purchased their subscription.

Jellyseer is a jellyfin comparable alternative to ombi.

They sold a bad product that needs fixed, bad software shouldn’t get an exception. The warning icons were probably not compliant and should never have left the factory.

It’s worse than that, people will argue shipping good code is impossible. Good testing is hard, so it’s avoided for things like unit tests. Something that’s only equivalent to basic QA in manufacturing. Every software functions is a design change and the system needs to be fully validated and tested. That’s means driving the car, and not shipping the code and using the users cars to prove your design.

Broken software shouldn’t be accepted as much as it is. Especially in safety critical systems like cars, especially when they remove manual controls for things like steering, brakes, hand brakes and door handles. Fly/drive by wire is more dangerous when the software is unreliable. Mechanical linkages fail immediately or take a long time. Bad software fails in uncertain and potentially chaotic ways.

A glass may have a spec that allows it to be filled to the brim. Doesn’t mean it’s a good idea, especially when you want to run up stairs with it.

Your going to spill water everywhere.

Because there are so many small parts to a processor you need 99.99+% at most stages to stand any chance of mass production. In this context 60-70% is seriously impressive. Millions of things have to be done right to get this type of yield.

In this situation a hub is still better. You can pack all the stuff away plugged into the hub for easier set up. If your plugging that all into your laptop, you’ll need to plug it all back in again when you move.

Pop OS is the same machine as the Ubuntu but with RGB.

People have attached pens to 3d printers and used them to write letters, effectively print. Most consumer 3D printers are useing or based on open source software.

I think the issue is, printers are relatively cheap to buy and replace. So building your own and programming it hasn’t been necessary. Where as 3d printing was completely in accessible before the reprap movement. 3D printing software is open source as it is motivated by people wanting to build their own machines that could build machines. Something you couldn’t easily buy.

It was very likely a designers decision. It forces the use the use case they wanted; wireless mice should be used wirelessly. I would bet they fought marketing and management to get this on the final product.

Marketing would want the mouse they can advertise as being useable with and wireless. Female ports are easier to mount and manufacture with they have depth to set the socket. So a plug on the front is much cheaper and easier to manufacture.

The fact the charging cable doesn’t get used in motion means it will last longer and you wouldn’t have people useing fraying cables on the front of their mouse.

People with exploits available that are unpatched are waiting for that end of support. It increases the value of their unreleased exploit.

A small computer, large capacity ssd and two WiFi interfaces (2x usb dongles, or dongle plus usb).

Small computer could be anything: raspberry pi (or generic and), nuc mini pc or laptop. If you want to use it without a plug you’ll need to add a battery, usb c powered devices could be more convent to power from a battery.

A ssd is better for this use case. Not because it’s faster, but they are more resilient to being knocked about and dropped. They are also much smaller, especially M.2, and aren’t fussy about how they are mounted.

The two WiFi interfaces would allow you to create a WiFi bridge to access the internet through a WiFi network and access your media server. It would need some configuration, you may also need to have the computer act as a router if you want to use multiple devices without reconfiguring.

It may be easier to have your device act as a WiFi hotspot and have the media centre automatically connect to it. This would make it difficult for multiple devices to use it simultaneously, and you could accidentally allow the media centre to do all its updating and downloading over your mobile connection.

This type of thing is going to be expensive and troublesome to configure unless your already experienced with that sort of thing.

I think a better solution, especially if you already have a media server. Is to set your media server for external access.

To get media when you don’t have internet, buy a large capacity flash drive (or external ssd/hdd). When you have access to your media server download all the content you want on to the drive. I think iOS jellyfin can do this without much modification.

Once out of range of your media server. Delete the content you’ve watched on your device (iPad) to free up space. Connect the external drive through the usb port on the iPad, copy over the next lot of content you want to watch. Disconnect and then watch the content.

Jellyfin can download the content, but you may need another app to play it when you don’t have access to the media server.

This approach lets multiple people access a much larger amount of media, effectively simultaneously. It doesn’t require a large amount of often expensive local device storage - you use cheap external storage. It much less expensive if it breaks or gets lost and has very little configuration -if you already have a media server running jellyfin.

It was 12 years ago he said he would put a man on mars in 10 years.

Anyone saying it works is lieing. Even if they have examples. Most of the time when companies self regulate it is to maintain control and avoid regulation. It’s a delaying tactic that allows them to exploit the mechanisms longer and minisme the impact that proper accountability would bring.

If self regulation was feasible we would never even be discussing it. It wouldn’t be a concept we would have to think about. It would just be the way things work and have always worked.

Probably not much for people on a self hosting community, but those that want to get away from subscriptions and steal your data as a service cloud providers that might need some reassurance that they’ll have a working system.

Nixos is an os that’s defined by its config stored in .nix files. Everything is defined here all the software and configurations. Two people with the same script will have the exact same os.

Any changes you make that aren’t in the scripts won’t be present when you reboot.

You could maintain a very custom linux distribution (kinda) by just maintaining these config scripts.

So a user wouldn’t need to install all required software and dependencies. They could get a nixos and the self-host config and adjust some settings and have a working system straight after install.

You know it’s a thunderbolt connection on a MacBook. They stopped using the USB symbol when they used the usb for thunderbolt and stopped using the mini display port.

This is going to be tracking customers location in supermarkets.